219
074: Exc-Compr
(Exciter – Compressor)
This effect combines a mono-type exciter and a com-
pressor. You can change the order of the effect connec-
tion.
075: Exc-Limiter
(Exciter – Limiter)
This effect combines a mono-type exciter and a limiter.
You can change the order of the effect connection.
a
[X] Exciter Blend
Sets the intensity (depth) of the Exciter effect
–100...+100
→Fx:011
b
[X] Emphatic Point
Sets the frequency range to be emphasized
0...70
→Fx:011
c
[X] EQ Trim
Table , “Sets the EQ input level,” on page 178
0...100
d
[X] Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 178
–15...+15dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 178
–15...+15dB
e
[C] Sensitivity
Sets the sensitivity
1...100
→Fx:002
f
[C] Attack
Table , “Sets the attack level,” on page 178
1...100
→Fx:002
Output Level
Sets the compressor output level
0...100
→Fx:002
g
Routing XCT→CMP, CMP→XCT
Switches the order of the exciter and compressor connection
h
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 177
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 177
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 177
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Routing
Compressor
LEQ HEQ
EQ Trim
Comp
Output Level
Envelope - Control
Exciter
Exciter
a
[X] Exciter Blend
Sets the intensity (depth) of the Exciter effect
–100...+100
→Fx:011
b
[X] Emphatic Point
Sets the frequency range to be emphasized
0...70
→Fx:011
c
[X] EQ Trim
Table , “Sets the EQ input level,” on page 178
0...100
d
[X] Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 178
–15...+15dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 178
–15...+15dB
e
[L] Ratio 1.0:1...50.0:1, Inf:1
Sets the signal compression ratio →Fx:003
f
[L] Threshold [dB] –40...0dB
Sets the level above which the compressor is applied →Fx:003
g
[L] Attack
Sets the attack time
1...100
→Fx:003
Release
Sets the release time
1...100
→Fx:003
h
[L] Gain Adjust [dB]
Sets the limiter output gain
–Inf, –38...+24dB
→Fx:003
i
Routin XCT→LMT, LMT→XCT
Switches the order of the exciter and limiter connection
j
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 177
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 177
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 177
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Routing
LEQ HEQ
EQ Trim
Exciter
Exciter
Limiter
Limiter
Gain Adjust
Envelope - Control
To Next Page
Loading...
