Korg Liverpool - Page 222

220
Effects
Mono – Mono Chain
076: Exc-ChorFlg
(Exciter – Chorus/Flanger)
This effect combines a mono-type limiter and a chorus/
flanger.
077: Exc-Phaser
(Exciter – Phaser)
This effect combines a mono-type limiter and a phaser.
a
[X] Exciter Blend
Sets the intensity (depth) of the Exciter effect
–100...+100
→Fx:011
b
[X] Emphatic Point
Sets the frequency range to be emphasized
0...70
→Fx:011
c
[X] EQ Trim
Table , “Sets the EQ input level,” on page 178
0...100
d
[X] Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 178
–15...+15dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 178
–15...+15dB
e
[F] Delay Time [msec]
Sets the delay time
0.0...50.0msec
f
[F] LFO Frequency [Hz]
Sets the LFO speed
0.02...20.00Hz
LFO Waveform
Selects LFO Waveform
Triangle, Sine
g
[F] Depth
Sets the depth of LFO modulation
0...100
Feedback
Sets the feedback amount
–100...+100
→Fx:020
h
[F] Cho/Flng Wet/Dry –Wet...–2:98, Dry, 2:98...Wet
Sets the effect balance of the chorus/flanger →Fx:010, 020
Output Mode Normal, Wet Invert
Selects the output mode for the chorus/flanger →Fx:060
i
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 177
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 177
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 177
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
+
Chorus/Flanger
Chorus/Flanger
Feedback
LFO: Tri / Sine
Cho/Flng Wet / Dry
Normal
Wet Invert
Output Mode
–
+
LEQ HEQ
EQ Trim
Exciter
Exciter
a
[X] Exciter Blend
Sets the intensity (depth) of the Exciter effect
–100...+100
→Fx:011
b
[X] Emphatic Point
Sets the frequency range to be emphasized
0...70
→Fx:011
c
[X] EQ Trim
Table , “Sets the EQ input level,” on page 178
0...100
d
[X] Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 178
–15...+15dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 178
–15...+15dB
e
[P] LFO Frequency [Hz]
Sets the LFO speed
0.02...20.00Hz
LFO Waveform
Selects LFO Waveform
Triangle, Sine
f
[P] Manual
Sets the frequency to which the effect is applied
0...100
g
[P] Depth
Sets the depth of LFO modulation
0...100
Resonance
Sets the resonance amount
–100...+100
→Fx:023
h
[P] Phaser Wet/Dry –Wet...–2:98, Dry, 2:98...Wet
Sets the phaser effect balance →Fx:010, 023
Output Mode Normal, Wet Invert
Selects the phaser output mode →Fx:060
i
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 177
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 177
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 177
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
+
LEQ
HEQ
EQ Trim
Exciter
Exciter
Phaser
Phaser
Resonance
LFO: Tri / Sine
Phaser Wet / Dry
Normal
Wet Invert
Output Mode
–
+