Basic information Basic operations
15
4. Press a tab (page tabs) to select a page.
As an example here, press the X-Y Control tab. The current
page indication in the upper left of the LCD screen will stay
the same.” You’ve selected the X-Y Control page.
Note: In some cases, there may not be any tabs in the upper
line.
3. Selecting and changing parameters
1. Press the parameter that you want to edit.
A green line will appear to the left of the parameter (edit
cell).
2. The parameter value in the edit cell can be edited
using touch-drag or with the VALUE controllers
(including the VALUE dial, the −/+ buttons, the
ENTER button and so on). For edit cells that can
accept numerical input, input the number by selecting
the edit cell, and then touching the same edit cell again
to display the numeric keypad.
Note: The way that the value will change depends on the
type of parameter or object.
For example, the values on a checkbox object can be
switched by pressing that object. To input a note and
velocity number using the keyboard, play a key while
holding down the ENTER button.
Note: You can use the Compare page menu command to
compare the sound you’re editing with the original unedited
sound.
VALUE controller
+/− buttons
VALUE dial
Use this when you wish to make large changes in a value.
To make detailed changes to the values, turn the dial while
holding down the ENTER button.
How the values change when using the −/+ buttons or the
dial when inputting the tempo
120.00 → 121.00 → 122.00 → ...
How the values change when using the −/+ buttons or the
dial while holding down the ENTER button
120.00 → 120.01 → 120.02 → ...
Popup buttons and popup menus
You can press a popup button to access a popup menu, and
then set parameter values.
Numeric keypad
After you select an edit cell that accepts numeric input, touch
the same cell again to display the numeric keypad.
Keyboard input
When entering a note number or a specific velocity as the
value of a parameter, you can use the keyboard to input the
setting. Hold down the ENTER button and play the note that
you wish to enter as a value. The note number or velocity
value will be input.
When the GLOBAL > Drum Kit page is displayed, you can
hold down the ENTER button and play a note to recall the
settings that have been assigned to that note. (If the
parameter you’ve selected expects you to enter a velocity
value, the velocity you played will be entered.)
In SAMPLING mode, you can hold down the ENTER
button and play a note to recall the index that is assigned to
that note.
4. Selecting and executing menu
commands
The menu provides commands that are specific to each page,
such Write (save) or Copy. The available functions will
depend on the current page.
For example, the utility functions in PROGRAM mode let
you write (save) the settings, perform convenient editing
operations such as copying settings between oscillators or
effects, “Sync” EGs so that you can edit two of them at once,
and so on.
To Next Page
Loading...
Need help?
General
