Effect priority order Error and confirmation messages
59
Effect priority order
Insert effect
When you’re using split settings, and the same
category of timbre is used for the main timbres and the
sub timbres (for example, if different E.PIANO
programs are used for both), the sub timbre’s program
will use the insert effect of the main timbre’s program.
This is because only one insert effect can be used for
each timbre category.
Master effect and EQ
When you switch performances, the master effect and
EQ settings saved in each performance will also be
recalled. However when you switch programs for a
timbre within a performance, the program’s master
effect and EQ settings will be recalled subject to the
following conditions.
Single settings (i.e., other than split or layer)
When you select a timbre (ON), and when you switch
programs for that timbre, the master effect and EQ
settings of the selected timbre will be recalled.
When switching from single → layer settings
When you switch from single settings to layer settings,
the program settings of the timbre you turned on first
will be recalled. These settings will not change even if
you subsequently switch the timbre’s program.
When you return from layer settings back to single
settings, the “Single settings” described above will
apply.
If you hold down the EXIT button and switch from
single to layer settings, the master effect and EQ
settings of the first timbre added to the layer will be
loaded.
When switching from single or layer → split set-
tings
The master effect and EQ will not change when you
switch to split settings. The master effect and EQ
settings that had been recalled for the single or layer
settings will continue to be used.
Error messages
Error and confirmation
messages
Can’t calibrate
Meaning:
Calibration could not be performed correctly.
Action: Try again.
Completed
Meaning:
The command was executed successfully.
Memory Protected
Meaning:
The internal programs or performances are
protected.
Action: In Global mode, turn off memory protect, and
then try the save (Write) operation again.
MIDI recv error (MIDI receiving error)
Meaning:
While receiving MIDI System Exclusive data,
the format of the received data was invalid,
for example, because the size of the data was
incorrect.
Action: Check the MIDI connections and MIDI data.
To Next Page
Loading...
Need help?
General
