Reference Guide
160
Combination/Multi mode: With a setting of “PRG (Program)”, the panpot setting in Global
mode is used (like in Program Play mode). With other settings, the value of all the indexes are
summarized.
With a setting of “P”, the send function in Program Play mode is applied here. With another
setting, the value of all indexes is summarized.
In general, you should set the panpot to “PRG” and send to “P.” You can edit the panpot setting
via MIDI when “PRG” or “OFF” is not selected. (The value changes in Combination Edit mode
and Multi mode.) You can also edit the send setting via MIDI. In this case, with a setting of “P”,
the send function in Program Play mode is added here. (The send balance between indexes
remains the same.) With a different setting, the values of all the indexes are summarized.
7A–7D Drum Kit2 Setup
These parameters allow you to set up Drum kit2. Operation is the same as for “6A–6D Drum Kit1
Setup” on page 158.
8A Drum Kit Copy
This function allows you to copy a drum kit to the internal Drum Kit 1 or 2.
To copy a drum kit, select the source and destination, position the cursor on OK?, then press the
[▲] button. The message “Are You Sure OK?” will appear. (A1: Drum Kit1, A2: Drum Kit2) Press
the [▲] button to copy, or the [▼] button to cancel.
LCD Parameter Range Description
8A
Source Drum Kit A1, A2, ROM 1–8 Select the source drum kit
Destination Drum Kit A1, A2 Select the destination drum kit
OK to Copy OK? Executes the copy
Note: The drum kit at the specified destination is overwritten when this function is executed. So
be careful that you don’t overwrite (lose) a valuable drum kit.
07A DRUM2 #01ø
152:Timpani
7A
7B 7C
07D PAN/SEND
Pan=CNT C=0 D=0
7D
07B KEY/TUNE/L ø
D#4 T+019 L+65
07C DECAY/ASGN ø
Dcy+00 Asgn:EX1
ø
08A COPY D.KIT
A1 ‡ A2 OK?
8A
To Next Page
Loading...
Need help?
General
