Start-up Guide
18
Performance settings
Parameters on the X5DR, or MIDI data sent from a computer or sequencer, allow you to make
performance settings such as volume level and pan of each track.
On the X5DR, use the [PAGE+] and [PAGE–] buttons to select a track, then use the [®] and [
√
]
buttons to select a parameter.
You may set the following parameters by sending the Controllers and RPN from the connected
computer or sequencer. You may also set all the parameters using the Exclusive messages.
For details, refer to “Received MIDI data” on page 32, and “MIDI Data” on page 66.
Parameters MIDI Data
Lev:
Volume.........................Controller #7
Pan:
Pan...............................Controller #10
Sen:
Send C/D .....................Controller #91/#93
Tra:
Transpose.....................RPN 02
Det:
Detune..........................RPN01
Bnd:
Bend range .................RPN 00
Pf:
Program Change filter
Df:
Damper filter
Af:
After Touch filter
Cf:
Control Change filter
KWTop/KWBtm:
Key Window
VWTop/VWBtm:
Velocity Window
MIDI Ch:
MIDI channel
Notes on Playing Back GM Scores
Before playing back performance data (GM scores) for a GM tone generator, make sure that the
following settings have been made in Global mode for correct playback.
•
See page 146 for the function of each parameter.
Set all the parameters in Multi mode to their default setting. To do so, use 23A SET TO GM (see
page 114), or transmit a GM System On message from a computer or sequencer.
Some GM scores may include non-GM MIDI data. In particular, Program Change messages may
be interpreted as Bank Select messages (for Bank A) when you are playing back a GM score that
uses Bank Select messages. (Bank G contains 128 GM sounds and Drum Programs.) If you wish
to play back performance data that has been created, assuming that it will be played back on the
X5DR, set the PRG parameter of the MIDI filter in Global mode to “ENA.” To play back other
performance data, set this to “NUM” to ignore the Bank Select messages.
0B Key Transpose +00
0C Velocity Curve 3
After Touch Curve 3
1A Scale Type Equal Temp
2A Note Receive ALL
2C–2D MIDI Filter PRG=NUM, EX=DIS, Others=ENA
To Next Page
Loading...
Need help?
General
