4-48 BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_04.fm
4 Putting into operation
4.4 Preparatory work
Important information before putting the machine into operation
Falling hazard when entering or exiting!
Entering or exiting incorrectly can cause injury.
► Keep the mandatory climbing aids clean.
► Use the mandatory climbing aids for entering and exiting the machine.
► Face the machine as you enter and leave it.
► Have damaged climbing aids replaced.
Requirements and information for the operating personnel
• The operating personnel (operator) must have read and understood
this Operator’s Manual before putting the machine into operation.
• The machine may only be put into operation by authorized personnel
that has been instructed.
• The machine may only be put into operation when the operator is
seated.
• Never get on a moving machine. Never jump off the machine.
• Before leaving the machine, lower the loader unit to the ground, stop
the diesel engine and apply the parking brake (hand brake).
• Carrying or transporting accompanying persons in the cabin and/or on
the machine is prohibited.
• Tell persons to leave the danger zone.
• Use the machine only in technically perfect condition in accordance
with its designated use and the instructions set forth in the operation
license, the Data Confirmation (Germany) and in the Operator’s
Manual, and only if you are fully aware of the risks involved in
operating the machine.
• Always observe the warning and information labels, and the load
diagrams, and take appropriate action.
• Immediately replace (or have replaced) damaged or illegible warning
and information labels with new ones.
• Check the rearview mirrors on the left and right for damage, and adjust
them
– see “MIrror adjustment on the left” on page 4-5 and
“Mirror adjustment on the right” on page 4-6.
➥ Have damaged rearview mirrors immediately replaced.
• Observe the checklists in the following tables and take appropriate
action – see “Check lists” on page 4-49.
To Next Page
Loading...
Need help?
General
