BA 35203_04 * 3.0 * 35203_04_03_Einleitung.fm 3-3
Introduction 3
3.2 Brief description of machine
Main components of machine
• Sturdy steel sheet frame; Engine stored on suspension elements.
• ROPS/FOPS tested cabin (roll-over/falling object protection);
Category I (standard), category II (optional)
– see chapter 4 “Cabin/control stand” on page 4-1.
- ROPS is the abbreviation for “Roll Over Protective Structure”.
- FOPS is the abbreviation for “Falling Object Protective Structure”.
• Deutz four-cylinder diesel engine, water-cooled and equipped with
exhaust after-treatment system. Exhaust emissions according to
standards 2011/88 and 2012/46 EC.
• Automotive drive, progressive hydrostatic axial-piston gearbox
- Standard – maximum speed 20 km/h (12.43 mph)
- Optional maximum speed 30 or 40 km/h
(18.64 or 24.85 mph)
• Hydraulic four-wheel power steering with emergency steering features
(diagonal steering option)
• Front and rear planetary steering axles, rear axle with oscillation.
• Service brake:
- With the 20 km/h (12.43 mph) version: brake disc on drive shaft of
the front axle. Braking effect is transferred to the rear axle via the
universal joint shaft.
- With the 30 or 40 km/h (18.64 or 24.85 mph) variant: brake disc on
front and rear axle drive shaft (optional).
• Parking brake on brake disc on front axle drive shaft.
For the operator's safety, the vehicle can optionally be outfitted with a seat
contact switch. In this case:
► The diesel engine will not start unless the operator is seated on the
seat.
► The drive switches off after 5 seconds if the load on the operator seat
is reduced when driving the machine.
The machine can be equipped with the “Telematic” option
(transmission of operational data, location, etc. via satellite)!
Please contact your dealer if you require information on the “Telematic”
option.
To Next Page
Loading...
