BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-17
Operation 5
5.4 Travel operation
Important information before putting the machine into operation
Accident hazard due to persons in the danger zone!
Serious injury or death can be caused by not staying clear of the danger
zone of the machine.
► Ensure that no one is in the danger zone.
► Stop all work movements immediately if persons enter the danger
zone.
► Seal off the danger zone with barriers.
If the oil temperature of the drive hydraulics is too high >105°C (>221°F),
the travel speed (machine travel dynamics) is automatically reduced by
50% until the oil temperature is below 105°C (221°F) in order to avoid
damage to the drive hydraulics.
► Have the cause for the high oil temperature checked or repaired by an
authorized service centre under all circumsances.
For the operator's safety, the vehicle can optionally be outfitted with a seat
contact switch. In this case:
► The diesel engine will not start unless the operator is seated on the
seat.
► The drive switches off after 5 seconds if the load on the operator seat
is reduced when driving the machine.
To Next Page
Loading...
Need help?
General
