BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_01.fm 4-1
Putting into operation 4
4 Putting into operation
4.1 Cabin/control stand
Important information on the cabin
• According to EN 15695-1:2009, the machine cabin does not protect
against substances that pose a risk to health and is therefore not
authorized for spraying applications. Only for use in the European
Community. Get informed on and follow the legal regulations of your
country.
• Only put the machine into operation if all cabin windows are free of dirt,
snow and ice.
• In forestry applications, the standard cabin does not offer enough
protection against falling trees or branches, or objects penetrating into
the cabin. Therefore, the machine has not been released for forestry
applications.
• A cabin damaged (deformed) in an accident may not be repaired but
must be replaced by an authorized service center.
• Welding, removing or drilling through elements of the cabin is
prohibited since this work modifies the cabin. Therefore it does not
correspond to the certification any longer.
For the operator's safety, the vehicle can optionally be outfitted with a seat
contact switch. In this case:
• The diesel engine will not start unless the operator is seated on the
seat.
• The drive switches off after 5 seconds if the load on the operator seat
is reduced when driving the machine.
EC cabin approval mark (agriculture and forestry certification option)
Machines with agricultural or forestry certification for use in the
European Community have an EC approval number A in accordance with
the 2009/75 EC Directives.
➥ e1 = EC approval mark.
► xxxx = approval number, also included in machine documents.
Putting into operation
To Next Page
Loading...
