BA 35203_04 * 3.0 * Sicherheit.fm 2-15
Safety 2
2.9 Maintenance
Maintenance
• Observe the intervals prescribed by law and those specified in this
Operator’s Manual for routine checks/inspections and maintenance.
• For inspection and maintenance, ensure that all tools and service
center equipment are adapted to the performance of the task
described in this Operator’s Manual.
• Do not use any damaged or malfunctioning tools.
• Have hydraulic hoses replaced within stipulated intervals even if no
visual defects can be detected.
• The machine and the engine must be stopped during maintenance.
• Once maintenance is over, correctly install safety equipment again that
has been removed.
• Wait for the machine to cool down before touching components.
Personal safety measures
• Avoid any operational mode that might be prejudicial to safety.
• Wear protective clothing and equipment (for example a hard hat,
protective gloves, safety boots).
• Tie back long hair and remove all jewelry.
• If maintenance on a running engine cannot be avoided:
- Only work in groups of two.
- Both persons must be authorized and trained for the operation of the
machine.
- One person must be seated on the operator's seat and stay in
contact with the second person.
- Keep a safe distance from rotating parts (for example from fan
blades, belts).
- Keep a safe distance from hot parts (for example from the exhaust
system).
- Perform maintenance only in well-ventilated rooms or rooms with an
exhaust-gas suction system.
• Safely lock/support machine components before starting work.
• Apply special care when working on the fuel system due to the
increased fire hazard.
To Next Page
Loading...
Need help?
General
