5-58 BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm
5 Operation
5.10 Attachments
Pick up the attachment
Fitting an attachment onto a Kramer quickhitch
Accident hazard due to incorrect locking of attachment!
Can cause serious injury or death.
► Check the lock pins and center bores of the attachment regularly for
damage.
► Have damaged parts immediately replaced by an authorized service
centre.
► Only lock and unlock empty attachments without any load.
► Ensure that the attachment is visibly locked on either side with lock
pins E.
1. Approach the machine to the attachment.
2. Lower the loader unit. To do this: push the joystick forward C.
3. Tilt the quickhitch facility forward. To do this, press the joystick to the
right B.
4. Drive the machine forward until the supports G of the quickhitch facility
are directly beneath the catch hooks of the attachment.
5. s Raise the loader unit until the quickhitch facility engages in the lifting
points of the attachment. To do this, pull the joystick downward D.
6. Tilt in the quickhitch completely. To do this, press the joystick to the
left A.
7. Lock the attachment. Press the rocker switch 82 on the joystick to the
left – see “Locking the attachment” on page 5-41.
The attachment is secured against unintentional unlocking. It can only be
unlocked from the quickhitch by means of the two-hand controls –
see “Unlocking an attachment” on page 5-41.
10
C
D
A
B
B
82
5.
Fig. 159
E
3
.
1
.
2.
G
4.
6.
To Next Page
Loading...
