Kramer 8115

BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-101
Operation 5
Table for values that have been determined
Enter the values that have been determined in the column “Entry”.
Designation Measure/determine Entry
GN Maximum authorized payload
Enter the calculated values in the
load diagram– see “Calculation formula for
stability (load diagram)” on page 5-102.
kg (lb.)
SN
Position of load centre:
pallet forks
Values entered in load diagram
according to ISO 14397-1.
500 (19.7)
600 (23.6)
700 (27.5)
mm (in.)
SN
Position of the load centre:
bucket or other attachments
mm (in.)
S Stability factor
Refer to table Required safety factors
(S) on page 5-102 for the values.
–
L1
Distance: between centre of
front axle and centre of gravity of
attachment
Measure
mm (in.)
L2
Axle base: between centre of front
axle and centre of rear axle
mm (in.)
L3
Distance: between load centre
(payload) and centre of front axle
mm (in.)
GH
Load on rear axle
(without load on loader unit)
Calculated kg (lb.)
F1
Measured load on rear axle
(without attachment, with extended
loader unit)
Determined on scales without attachment. kg (lb.)
F2
Load reduction on rear axle due to
installed pallet forks/attachment
Calculated, or measured if scales and an
attachment are available.
kg (lb.)
GA Weight of pallet forks/attachment
Ask attachment manufacturer.
kg (lb.)
SA
Centre of gravity of pallet forks/
attachment
–
p
max
Material density of load
Calculated: depends on material picked up
with the bucket.
t/m³
(lb./ft³)
V Bucket capacity (ISO 7546) Ask attachment manufacturer. m³ (ft³)
M Payload mass Calculated. kg (lb.)