6-2 BA 35203_04 * 3.0 * 35203_04_06_Transport.fm
6 Transport
Disabling the variable displacement pump
The high pressure valves must be opened before towing in order to avoid
damage (high pressure) to the variable displacement pump when towing
away the machine.
Disabling the variable displacement pump (neutral position)
1. Apply the parking brake.
2. Stop the engine and remove the starting key.
3. Unscrew both high-pressure relief valves A on the variable
displacement pump about 2 revolutions (wrench size 22 mm – 0.87 in).
Towing the machine
Tow away the machine as follows:
The towing devices at the vehicle rear A and on the frame at the front B is
only certified for towing the machine. They are not certified as a trailer
coupling, for fitting attachments or for raising, loading and tying down the
machine.
1. Put the towing vehicle (with sufficient traction force and a safe braking
system) in the towing position.
2. Attach suitable towing equipment (towing bar) to the towing facilities A
or B (eyelets) on the machine.
➥ Bear in mind the machine’s dimensions and weights.
3. Tow the machine out of the danger zone at walking speed.
➥ If possible, run the diesel engine at idling speed when towing.
To Next Page
Loading...
