BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm 7-13
Maintenance 7
Air conditioning
(option)
18
About 0.85 kg
(1.87 lbs.)
Refrigerant
19
R 134a/DIN 9860 Year-round
Washer system
Water
1.0l (0.26gal)
Antifreeze
2.0l (0.52gal)
Cleaning agent
5
Water 33% + antifreeze
67%
Year-round
−20 °C
(−4 °F)
Aggressive media
(option)
20
As required
Anticorrosion
protection
ELASKON 2000 ML,
ELASKON UBS light,
ELASKON Aero 46 special,
ELASKON Multi 80
Year-round
1. The capacities indicated are approximate values; the oil level check alone is relevant for the correct oil level.
2. Bear in mind the safety data sheet during maintenance.
3. Specification: CJ-4, ACAE E4/E6/E7/E9. Also see: www.deutz.com/file/...de.0/flyer_betriebsstoffe_de.pdf.
4. In order to avoid engine damage and loss of warranty, use only antifreeze released according to DEUTZ DQC CA-14, CB-14, CC-14. For other released an-
tifreeze products, see: www.deutz.com/file/...de.0/flyer_betriebsstoffe_de.pdf.
5. Compound table – see chapter 9 “Coolant” on page 9-18 or the manufacturer’s information on the packaging.
6. The antifreeze must be replaced every 2 years by an authorized service center.
7. The entire fuel system may be emptied, and the fuel tank may be cleaned only by an authorized service center.
8. In order to avoid engine damage and loss of a possible warranty, do not add any additives to the diesel fuel!
9. If fuels are used that do not comply with the standards in the table, warranty rights shall not apply in case of diesel engine damage.
10. To avoid damage and loss of any warranty on the exhaust after-treatment system, only the urea solutions released according to ISO 22241-1 (DIN 70070)
may be used.
Only an authorized service center may empty or clean the urea container.
11. Specifications: MIL-L-2105B; API - GL5
12. Capacity for each axle or planetary drive
13. In order to avoid a failure of the braking system, do not mix this brake fluid (ATF) with other brake fluids
14. Complete refill of the hydraulic system about 103 l (27.22 gal)
15. DIN 51 524
16. Used in Scandinavian countries only
17. Before assembly: lubricate the bolts, shafts and bearing with Fuchs "gleitmo" 800. After assembly: lubricate the shafts and bolts via grease fittings.
18. Maintenance work may only be performed by technically trained personnel.
19. Bear in mind the safety data sheet during maintenance.
20. Have the sealing checked and repaired at least once a year by ELASKON – see the ELASKON servicing pass supplied with the machine.
Component/application Capacities
1
Fluid/lubricant
2
SAE grade Specification
Season/
temperature
To Next Page
Loading...
