Kramer 8115

7-26 BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm
7 Maintenance
Lubricating the loader unit
Information
Maintenance intervals – see “Maintenance plan” on page 7-3.
Lubricant – see “Fluids and lubricants” on page 7-12.
Loader unit lubrication points (overview):
A Lubricate the grease zerk of the tilt cylinder bearing on the frame every
10 operating hours. Lubricate more frequently when in heavy-duty
operation.
B Lubricate the grease zerk of the loader unit bearing every 10 operating
hours. Lubricate more frequently when in heavy-duty operation.
C Lubricate the grease nipple on the lift ram bearing on the frame every
10 operating hours.
D Lubricate the grease zerk of the tilt rod bearing every 10 operating
hours. Lubricate more frequently when in heavy-duty operation.
E Lubricate the grease zerk of the tilt ram bearing every 10 operating
hours.
F Lubricate the grease zerk of the lift ram bearing every 10 operating
hours. Lubricate more frequently when in heavy-duty operation.
G Lubricate the grease zerks of the tilt lever bearing every 10 operating
hours. Lubricate more frequently when in heavy-duty operation.
H Lubricate the grease zerks of the quickhitch bearing every 10 operating
hours. Lubricate more frequently when in heavy-duty operation.
Lubricate the loader unit as follows
1. Set the quickhitch to a horizontal position.
2. Only raise the loader unit until all grease zerks can be accessed
without any risk.
3. Stop the engine.
4. Apply the parking brake.
5. Switch off the starter and remove the starting key.
6. Apply grease to the lubrication points with a grease gun.
Fig. 254
A
B
C
Fig. 255
D
E
H
G
F
D
D