BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm 7-47
Maintenance 7
Adding hydraulic oil
1. Check the hydraulic oil level
– see “Checking the hydraulic oil level” on page 7-45
2. Clean the area around the filler and breather filter B.
3. Place a container under the hydraulic oil reservoir to collect the oil.
4. Open breather filter B by hand.
5. Top off hydraulic oil with the filter insert in place.
6. Check the hydraulic oil level on oil level sight glass A.
7. Add if necessary and check again.
8. Firmly close breather filter B by hand.
Excess hydraulic oil is released via the breather filter during loader unit
operation.
► Drain the oil into a suitable collecting container until the oil level can be
seen in the oil level glass A.
Maintenance intervals – see “Maintenance plan” on page 7-3.
Specifications and fill quantities – see “Fluids and lubricants” on
page 7-12.
To Next Page
Loading...
