BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm 7-51
Maintenance 7
Checking/replacing the battery
The battery is located in the engine compartment, on the right (in travel
direction) beside the radiator.
It is low in maintenance and no fluid needs to be refilled under normal
operating conditions. However, have it checked according to the
maintenance schedule to ensure that the fluid level is between the MIN
and MAX marks.
In order to avoid damage to the machine electronics, only use batteries of
the specified capacity!
If the battery is low, charge it with a tested and automatically controlled
battery charger.
In order to avoid a short circuit due to the wrong chronological order when
connecting or disconnecting the battery cables:
► First disconnect the negative terminal, and then the positive terminal.
► When connecting: First the positive terminal, and then the negative
terminal.
1. Park the machine on level ground.
2. Lower the loader unit.
3. Apply the parking brake.
4. Stop the engine and remove the starting key.
5. Open the engine cover.
6. Remove the key with the "battery master switch" if the machine is
equipped with this option
– see chapter 4 “Battery master switch (option)” on page 4-18.
7. Remove the cover B on the right counterweight.
8. Remove the cover C on the positive terminal (+) large clamp.
9. Remove the battery cables :
➥ First at the negative terminal (-) small clamp,
➥ then at the positive terminal (+) large clamp.
10.Remove the battery fixture D.
11.Replace the battery with a new one.
➥ Use battery with prescribed capacity
– see chapter 9 “Electric units/light bulbs” on page 9-12.
12.Attach the battery fixture D.
13.Install the battery cables :
➥ first on the positive terminal (+) large clamp,
➥ then at the negative terminal (-) (small clamp).
14.Attach the cover C to the positive terminal.
15.Switch this on again with the "battery main switch" option.
To Next Page
Loading...
