7-54 BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm
7 Maintenance
Checking/replacing relays and fuses on the board
The relays and fuses are located behind the switch console on the left A
and right B in the cabin.
Blown fuses indicate overloading, short circuits or wiring harness damage.
► Have the electrical system checked before installing new fuses!
► Only use fuses with the specified load capacity (amperage).
1. Park the machine on level ground.
2. Lower the loader unit.
3. Apply the parking brake.
4. Stop the engine and remove the starting key.
5. Remove knurled thumb screws C from the switch panel.
6. Replace the malfunctioning fuse or relay.
7. Fuse and relay descriptions and output indications
– see chapter 9 “Fuse assignments (pos. A)” on page 9-13 and
Switching relay assignment on page 9-15.
To Next Page
Loading...
