3-20 BA 35203_04 * 3.0 * 35203_04_03_Einleitung.fm
3 Introduction
Attachments for EURO quickhitch
The machine manufacturer has not released any attachments for this
quickhitch!
Damage to machine due to attachments that have not been released.
► If attachments that are not released are used, conformity (stability test)
in accordance with the EC machine guideline or the EN 474-3 standard
must be checked and documented by an authorized service centre.
Refer to the following information sheets in section Stability calculations
for attachments from other manufacturers on page 5-100 for the stability
test.
Machine travel on public roads with a full bucket is prohibited in the
Federal Republic of Germany!
Observe the following for attachments that are not certified for use on
public roads in the Federal Republic of Germany:
► Remove the attachments for transport on public roads.
► Load the attachment on a transport vehicle and transport it to the job
site.
• If uncertified attachments are installed, or if parts of the quickhitch or
attachment are subsequently modified or replaced, the operation
license and the warranty become void.
• In addition to the Operator’s Manual, observe and instruct the operator
in all other generally applicable, legal and other mandatory regulations
relevant to accident prevention and environmental protection.
• Please contact your dealer if you require more information on the
quickhitch and the specific attachments.
To Next Page
Loading...
