BA 35203_04 * 3.0 * 35203_04_03_Einleitung.fm 3-31
Introduction 3
Information labels
Tie-down point labels for loading and tying down the machine!
Eye hooks for tying down the machine B during transport, and eye hooks
A for loading the machine
– see chapter 6 “Loading the machine on a transport vehicle” on page 6-4
and Crane-lifting the machine on page 6-6.
Located on left and right of machine frame above the front axle
attachment and at the rear under the machine.
Information label: Maximum design-specific speed
Design-specific max. machine speed 20 kph standard (30/40 kph option).
Only for use in the European Community.
Located at the rear of the machine and on the left/right of the
counterweight.
Information label: Fuel filler opening!
Use only the diesel fuels indicated.
• DIN EN 590 (EU) / ASTM D975-94 (USA)
• Do not use diesel fuel with additives.
If other fuels are used, warranty rights shall not apply in case of diesel
engine damage (guarantee)!
Located near the filler inlet of the fuel tank (left side of machine).
Label: control lever (joystick) operation
A Travel direction: (F) forward/(R) reverse and (N) neutral position
B Additional control circuit with additional functions (option)
C Automatic bucket repositioning (option) or front socket power supply
D Operation: Locking/unlocking the attachment fitted on the quickhitch
facility
E Differential lock
F Operation of 4th control circuit (option)
G Loader unit wiring diagram operation: raise/lower and tilt in/out
(optional floating position)
Description of loader unit operation
– see chapter 5 “Operating hydraulics” on page 5-35.
Located on the right on the side window, next to the control lever
(joystick).
To Next Page
Loading...
