4-4 BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_01.fm
4 Putting into operation
Folding back the control lever base
Enter and leave the cabin only by the left door as a rule. Use the access
on the right in an emergency only!
Danger of accident if the control lever base is folded down too early!
May lead to serious injury or death due to uncontrolled movement of the
vehicle or the loader unit.
► Stop the machine.
► Lower the loader unit to the ground.
► Apply the parking brake.
► Stop the engine and remove the starting key.
► Move control lever 10 (joystick) back and forth several times to release
the pressure
► Secure the control lever (joystick) .
The control lever base is damaged if the load on it is too heavy.
► Do not use handle C to ease your entrance into the cabin.
1. Fully raise the control lever base to position A with handle C
➥ The gas strut keeps the control lever base in the top position.
2. Fold the control lever base down to position B after entering or leaving
the cabin.
➥ The gas strut keeps the control lever base in the lower position.
Fig. 47: Control lever base
10
C
B
A
To Next Page
Loading...
