(from 1 to 4)
Y/CV
Connect to the video acceptor which can be either composite
video (Y/CV), s-Video (Y/CV, P
B/C ) or component video
(Y/CV, P
B/C, PR)
22 PB/C
23 PR
24 UXGA 1 IN 15-pin HD Connector Connects to the UXGA (analog interface) graphics source 1
25 UXGA 2 IN 15-pin HD Connector Connects to the UXGA (analog interface) graphics source 2
26 AUDIO IN UNIV. IN RCA
Connectors (from 1 to 4)
L/S/PDIF Connect to the left unbalanced stereo analog audio source;
Alternatively, connect to a digital audio source
27 R Connect to the right unbalanced stereo analog audio source
28 AUDIO IN 3.5 Mini Jack UXGA 1 Connects to the unbalanced stereo analog audio source 1
29 UXGA 2 Connects to the unbalanced stereo analog audio source 2
30 AUDIO OUT RCA
Connectors
L Connect to the left unbalanced stereo analog audio acceptor
31 R Connect to the right unbalanced stereo analog audio acceptor
32 S/PDIF Connect to a digital audio acceptor
33 AUDIO
PROG
Program Button Push to upgrade to the latest Kramer audio firmware
Release for normal operation
34 Terminal Block Connector Connect to a PC for audio firmware upgrade
35 HDMI 1 IN Connector Connect to the HDMI 1 source
36 HDMI 2 IN Connector Connect to the HDMI 2 source
37 HDMI OUT Connector Connect to the HDMI acceptor
38 UXGA OUT 15-pin HD Connector Connects to the video acceptor that displays the scaled output
In the default HDTV mode, the signal goes out via 3 PINS: PIN
1 is P
r
, PIN 2 is Y, PIN 3 P
b
39 RS-232 9-pin D-sub Connector Connects to PC or Serial Controller
40 Power Connector with Fuse AC connector enabling power supply to the unit
To Next Page
Loading...
