becomes colored green
1
.
When the operation is completed, all 4 check-boxes will be colored green
and the status bar message: Memory Verify Pass appears
2
:
Figure 28: Atmel – Flip Window (Operation Completed)
10. Close the “Atmel – Flip” window.
11. Disconnect the power on the VP-728.
12. If required, disconnect the rear panel AUDIO PROG. terminal block
connector on the VP-728.
13. Release the rear panel AUDIO PROG. button, using a small screwdriver.
14. Connect the power to the VP-728.
Upon initialization, the new VP-728 audio software version shows in the
Information menu (see section
8.8).
1 See also the blue progress indicator on the status bar
2 If an error message: “Not Finished” shows, click Run again
To Next Page
Loading...
