Operation
12
Pos: 4.50 /Übersc hriften/Übersc hriften 3/K-O/M /Menü 1-4 "Bin destartverzög erung" @ 369 \mod_144178519 5167_78.doc x @ 2703590 @ 3 @ 1
2.2.2 Menu 1-4 “Tying Start Delay”
Pos: 4.51 /BA/In fo-Center/ALL E Terminals in ei nem - ISOBUS , Delta, BETA I I (ab BJ 15/16)/ ALLE Ter minals/Rundballen pressen/Menü 1-4 _4 Bindestart verzögerung_Einl eitung_ALLE T erminals_Co mprima_Fortim a @ 357\mod _14388391816 74_78.docx @ 2657813 @ @ 1
Tying start delay is used to set the period of time that has to be passed between completion of
round bale in the bale chamber and triggering the tying process. The tying start delay is set in
seconds.
Pos: 4.52 /BA/In fo-Center/ALL E Terminals in ei nem - ISOBUS , Delta, BETA I I (ab BJ 15/16)/ ALLE Ter minals/Rundballen pressen/Menü 1-4 Bindestart verzögerung (Foli enbindung)_Bild _ALLE Ter minals_Compri ma CF CV_+X-tre me @ 367\ mod_14413482 02818_78.doc x @ 2696546 @ @ 1
Fig.
Pos: 4.53 /BA/In fo-Center/ALL E Terminals in ei nem - ISOBUS , Delta, BETA I I (ab BJ 15/16)/ ALLE Ter minals/Rundballen pressenMenü 1-4 Bindestart verzögerung (Folie nbindung)_T ext_ALLE Termi nals_Compri ma CF CV_+X-tre me @ 409\ mod_14502684 78634_78.doc x @ 2893588 @ @ 1
Prerequisite
– Menu 1 “Settings Baler” is active, refer to chapter Terminal - Menus, menu 1 “Settings
Baler”.
– Film tying is selected in menu 1-8 “Selection Type of Tying”, refer to chapter Terminal -
Menus, menu 1-8 “Selection Type of Tying”.
• Select to open the menu.
The display shows menu 1-4 “Tying Start Delay”.
Feature film tying
For film tying, the tying start delay is set automatically to 0.0 s. KRONE recommends this
setting.
At high driving speeds, the tying start delay for film tying can be set to a minimum:
• Increase or reduce the value, refer to chapter entitled Terminal - Menus “Changing the
Value”.
• Save value.
Pos: 4.54 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_119617 5311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
