Krone Swadro 810 - Position of Safety Stickers on Machine

94 pages

To Next Page

To Previous Page

Safety

Pos: 12.10 /Überschrif ten/Überschrif ten 2/K-O/L age der Sicher heitsaufkleber a nd erM aschine @ 0\mod_11 95634967326_78. doc @ 1020

4.3 Position of the Adhesive Safety Stickers on the Machine

Pos: 12.11 /BA/Sic herheit/Auf kleber/Schwader/ Sicherheitsauf kleber Schwader 807/810/907 @ 1 \mod_1202 220808716_78. doc @ 58071

SW810018

Fig. 2

Main Page

Table of Contents2
Table of Contents3
Foreword6
Introduction7
- Purpose of Use7
- Validity7
- Identification Plate7
- Information Required for Questions and Orders8
- Intended Use9
- Technical Data9
Safety14
- Introduction14
- Identification of the Hazard Warnings14
- Position of the Adhesive Safety Stickers on the Machine16
- Position of the General Information Labels on the Machine18
- Identifying Symbols in the Operating Instructions19
- Identification of the Hazard Warnings19
- Safety Instructions and Accident Prevention Regulations21
- Hitched Implements22
- PTO Operation23
- Hydraulic System24
- Tyres24
- Maintenance25
- Working in the Vicinity of Power Transmission Lines26
- Unauthorised Conversion/Modification and Spare Parts Production26
- Inadmissible Modes of Operation26
- Safety Instructions on the Machine26
Commissioning27
- First Installation27
- Preparations on Tractor28
  - Adjusting the Lower Suspension Arms28
- PTO Shaft29
  - Length Adjustment29
Table of Contents30
- Height of Tractor Lower Suspension Arms30
Start-Up31
- Mounting Onto the Tractor31
- Hydraulics32
  - Special Safety Instructions32
  - Connecting the Hydraulic Lines33
- Lighting Connection34
- Connecting the Electrical Controls35
- Install the PTO Shaft36
Driving and Transport37
Operation39
- Overload Protection39
- From Transport into Working Position40
- Removing the Tine Protections from the Tine Tips40
- Lowering the Rotor Arms into Working Position40
- Adjusting the Rear Swath Cloth41
  - Height Adjustment of the Swath Former42
- Adjusting the Front Swath Cloth (Swadro 810)42
- Adjusting the Rear Swath Cloth (Swadro 907)44
  - Adjusting the Swath Former Lengthwise45
  - Height Adjustment of the Swath Former45
- Swivel Tine Arms to Working Position46
  - For Design with Collapsible Tine Arm47
- Move the Hoop Guards to the Working Position48
- Adjusting the Raking Height Mechanically49
  - Adjusting the Raking Height - Electrically (Optional for Swadro 810, Swadro 907)50
  - Function of Switches on the Control Unit (Optional for Swadro 810, Swadro 907)50
- Travelling on an Incline52
- Travelling Speed und Drive Speed52
- Switching from Working Position to Transport Position53
- Move the Hoop Guards to Transport Position53
- Swivelling Tine Arms into Transport Position54
  - With Rigid Tine Arms Design54
  - For Design with Collapsible Tine Arm55
- 8.16 Pushing the Swath Cloth into Transport Position56
- 8.17 Pushing the Swath Cloth into Transport Position57
- Raising the Rotor Arms to Transport Position58
- Protecting the Tine Tips (Transport Position and Swather Switched Off)58
- 8.20 Switching from One Side Swath to Two Individual Swaths59
- Switching from Two Individual Swaths to One Side Swath (Swadro 810)60
- Parking61
Settings62
- To Adjust the Rotor Running Gear62
- Regulating Direction of Travel63
- Adjustable Throttles64
Maintenance65
- Special Safety Instructions65
- Compensation Spring(S)65
- Test Run65
- Tightening Torques66
- Tightening Torques (Countersunk Screws)67
- Testing the Screws on the Tines67
- Tyres68
- Replacing the Tine Arms(in Case of Repair)70
- Replacing the Tine Arms(in Case of Repair)72
Maintenance - Lubrication Chart74
- Special Safety Instructions74
- PTO Shaft75
Maintenance - Lubrication Chart76
- Lubrication Chart77
Maintenance - Hydraulic System79
Maintenance - Gearbox80
- Filling Quantities and Lubrication Designations for Gearboxes80
- Rotor Gear / Rotor Housing80
- 14.3 Transfer Gearbox Front and Rear81
Special Equipment82
- Tine Loss Safeguard82
- Chain for Height Restriction of Suspension Arms83
Placing in Storage84
- Special Safety Instructions84
- At the End of the Harvest Season85
- Before the Start of the New Season86
- Special Safety Instructions86
Malfunctions - Causes and Remedies87
- Special Safety Instructions87
Appendix89

Krone Swadro 810 - Position of Safety Stickers on Machine

Table of Contents

Other manuals for Krone Swadro 810

Related product manuals