Commissioning
29
Pos: 14.9.1 /Übersc hriften/Übersc hriften 2/F-J/G elenkwelle @ 0\ mod_11997818 79794_78.doc @ 34542
5.3 PTO shaft
Pos: 14.9.2 /Übersc hriften/Übersc hriften 3/K-O/L ängenanpassu ng @ 1\mod_ 1201687632810_ 78.doc @ 535 89
5.3.1 Length adjustment
Pos: 14.9.3 /BA/ Erstinbetriebnah me/Gelenkwelle/ Schwader/Lä ngenanpassung Bil d Schwader @ 2\mod_1202 364902991_78. doc @ 58848
3
2
SW9070007
1
Fig. 5
Pos: 14.9.4 /BA/ Erstinbetriebnah me/Gelenkwelle/ Schwader/Lä ngenanpassung_ mit Weitwin kelTe xt_Schwad er@ 2\mod_1 202365111491_ 78.doc @ 58868
The PTO shaft (1) length must be adjusted.
• Disassemble the PTO shaft.
• Install each half (1) and (2) on the tractor and machine side respectively.
(The wide-angle coupling must be installed onto the machine. Observe the marking on
the PTO shaft.)
• Position rotary rake in the shortest PTO shaft position setting. (Completely the three-
point frame inwards.)
• For additional operating instructions refer to the operating instructions of the PTO shaft
manufacturer.
Note
Check the swivel range and clearance of the PTO shaft! Damage can be caused if the tractor
or the machine touch the PTO shaft. (e.g. hitching device, hitching frame)
Pos: 14.10 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
