Krone Swadro 810 - Adjustable Throttles for Rotor Speed

Settings
64
Pos: 28.1 /Übersc hriften/Übersc hriften 2/A-E/Ei nstellbare Dross eln @ 0\mod_1 19729589226 0_78.doc @ 171 99
9.3 Adjustable throttles
Pos: 28.2 /BA/Sich erheit/Gefahr enhinweise/Eins tellarbeiten g ezogene Maschin en@ 0\mod_1 19971701103 8_78.doc @ 3398 0
Danger! - Unexpected movements of the machine
Effect: Danger to life or serious injuries.
• Setting tasks must only be performed when the drive is switched off and the engine is at
a standstill!
• Switching off the engine
• Remove the ignition key.
• Secure the machine against the possibility of rolling back.
Pos: 28.3 /BA/Eins tellungen/Dross el/Drosseln ein stellen allgemei nerT ext SW 8 07_810_907 @ 1 6\mod_12348 66857148_78.d oc @ 197079
You can use the adjustable throttles to adjust the lowering speeds of the rotors on the machine.
The throttles are set in the factory so that the rotor is lowered into the headland position or out
of the headland position into the working position with a time delay (front, rear).
To allow for different types of tractors and oil pressures, the throttles may need to be
readjusted.
Pos: 28.4 /BA/Eins tellungen/Dross el/Hinweis Ei nstellung an d en Drosseln (Aus wirkung) @ 7\m od_121552522 3776_78.doc @ 103417
Note
Adjustment on the throttles
Even the smallest adjustments to the stud bolts or throttle setting screws may significantly
change the lifting and lowering speed.
Pos: 28.5 /BA/Eins tellungen/Dross el/Hinweis S echskantmutter/I mbusschraube kontern @ 7\ mod_121552538 9308_78.doc @ 103437
Note
Adjustment on the throttles
After an adjustment has been made to the throttles, lock the hexagonal nuts and Allen head
screw. Then test functionality.
Pos: 28.6 /BA/Eins tellungen/Dross el/Drossel 3 Bil dS W 807_810 _907 @ 16\m od_12348659858 35_78.doc @ 197028
SW9070030
3
c/d
Fig. 39
Pos: 28.7 /BA/Eins tellungen/Dross el/Drossel (3) hinterer Kreisel @ 7\mod_121 5523600901_ 78.doc @ 103 377
Throttle 3
Lowering speed of the rear rotor.
• Loosen hexagonal socket head screw (c).
• Screw stud screw (d) in or out (unscrewing it increases the flow of oil and thus increases
the speed at which the rear rotor is lowered.)
Pos: 29 /BA/----- Seitenumbruch---- -- @ 0\mod_1 196175311226 _0.doc @ 416 5