Krone Swadro 810 - Raising Rotor Arms to Transport Position; Protecting Tine Tips in Transport

Operation
58
Pos: 20.60 /BA/Be dienung /Sch wader/Kreiselar me senken/he ben/Kreiselarm e heben SW 807 _809_810_907 @ 7 6\mod_130 9770278007_78 .doc @ 664314
8.18 Raising the Rotor Arms to Transport Position
SW810014
1
2
1
SW9070020
1
2
Fig 32
Note
Make certain the transport locks engage correctly and the actuator rope is not tight.
Swadro 907
The locks (1) on the Swadro 907 have engaged correctly when the white spotlights (2) can be
seen from the tractor with the outrigger arms in vertical position (front rotor and rear rotor).
Swadro 807, Swadro 809, Swadro810
Perform a visual inspection to ensure the locks (1) have engaged correctly.
• Lift the lock (1) with the pull rope (2) and position the activation lever of the tractor
hydraulics to "Lift".
• Tighten the pull rope until the supporting bolt on the swath rake arm is guided up to the
locked setting for working position. Continue lifting the swath rake arm until the lock (1)
engages in the transport position.
Pos: 20.61 /BA/Be dienung /Sch wader/Zinken / Zin kenarme/Zi nkenschutze anbring en SW 807/8 10/907 @ 2\mo d_120272411 6314_78.doc @ 60356
8.19 Protecting the Tine Tips (Transport Position and Swather Switched Off)
SW9070021
1
1
2
Fig. 33
The tines must be fitted with a tine guard that is lower than 2 m in transport position or when
parking the machine. The tine guards are located on the front of the hoop guard.
• Connect the tine guards (1) onto the tines.
Pos: 20.62 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65