Operation
56
Pos: 20.51 /Überschrif ten/Überschrif ten 2/P-T/Sch wadtuch in Tr ansportstellung sc hieben @ 2\m od_120272114 0189_78.doc @ 60238
8.16 Pushing the Swath Cloth into Transport Position
Pos: 20.52 /Ab kürzungen /Abkürz ungen sprac hneutral/Schwad er/Swadro 807 / Swadro 809 / S wadro 810 @ 76\mod_1309 772465864_0.d oc @ 664398
Swadro 807 / Swadro 809 / Swadro 810
Pos: 20.53 /BA/Be dienung /Sch wader/Schwadtuc hi nT ransportst ellung schieb en @ 78\mod_13 13675954322 _78.doc @ 69 3589
Caution! - Do not turn on the drive
Effect: Damage to the machine
• Switch off the engine
• Remove the ignition key.
• Secure the machine against the possibility of rolling back
If the swath cloth is in the transport position, the PTO shaft must not be turned on.
SW810013_1
3
2
SW810033_1
1
1
Pos.II
4
Pos.I
Fig. 30
The swath cloth must be pushed as far in as possible for transport (see photo).
• Fold the tine arms.
• Fold the hoop guard (3).
• Reinstall socket pin (4) from pos.I to pos.II and secure in place.
• Loosen cone grip (1) and set screw.
• Push the swath cloth (2) in as far as possible.
• Tighten the cone grip (1) and set screw again.
Note
To avoid any damage caused by the tines on the front swath cloth, the front swath cloth must
be folded over to the "One side swath" in transport position (see chapter entitled “Switching
from Two Individual Swaths to One Side Swath”).
Pos: 20.54 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
