Operation
49
Pos: 20.27 /BA/Be dienung /Sch wader/Einstellen der Arbeitstiefe - mechanisch @ 2\mod_12 02735419033_78. doc @ 60774
8.10 Adjusting the raking height mechanically
SW700015
1
Figure 23
The raking height is adjusted by means of a hand crank (1), located each time to the left and
right of the rotary arm.
The raking height must be adjusted so that the tine tips lightly touch the ground. If necessary,
this adjustment can be corrected during operation.
This means:
If the setting is too high, the forage is not completely taken up.
If the setting is too low, the danger exists of soiling the forage, damaging the sward and causing
considerable wear of the double coil spring tines.
Pos: 20.28 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
