Operation
40
Pos: 20.5 /Übersc hriften/Übersc hriften 2/U-Z/Vo nTr ansport in Ar beitsstellung @ 2\mod_120 2466185276_78.d oc @ 59662
8.2 From transport into working position
Pos: 20.6 /BA/Sich erheit/Gefahr enhinweise/Schw ader/Gefahr M aschine absen ken @ 5\mod_12 13694805078_ 78.doc @ 887 74
Danger! – Lowering the machine into working position
Danger to life, injuries or damage to the machine.
• Lower the machine only when you are absolutely sure that neither persons, animals nor
objects are in the swivel range of the machine.
• Switch the PTO on only when the machine is in working position, the collapsible tine
arms are swivelled into the working position and the hoop guards are turned downwards.
Pos: 20.7 /BA/Bedi enung /Schw ader/Zinken / Zi nkenarme/Zin kenschutze entfern en SW 807/81 0/907 @ 2\m od_120246703883 9_78.doc @ 59 738
8.3 Removing the tine protections from the tine tips
SW9070021
1
1
2
Figure 14
• Remove the tine protections (1).
• Insert the tine protections into the support (2) (right and left side of the machine) and and
secure with the linch pin.
Pos: 20.8 /Übersc hriften/Übersc hriften 2/K-O/Kr eiselarme in die Ar beitsstellung a bsenken @ 37\mod_1263 474967690_78. doc @ 339871
8.4 Lowering the rotor arms into working position
Pos: 20.9 /BA/Bedi enung /Schw ader/Kreiselar mes enken/heb en/Kreiselarme se nken- mech anisch SW 807 _810_907 @ 2\ mod_12024668 47230_78.doc @ 5 9719
• Activate the single-action control valve on the tractor and apply pressure to the hydraulic
cylinder. This relieves the load on the lock.
• Pull on the actuator rope to disengage the lock. Leave the rope under tension.
• Slowly lower the external rotor with the control valve until the wheels are resting on the
ground.
• Release the pull rope.
Note
Leave the control valve in "Lower" position when using the machine for work
Pos: 20.10 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
