Krone Swadro 810 - Install the PTO Shaft; Danger: Rotating PTO Shaft Hazards

Start-up
36
Pos: 16.33 /Überschrif ten/Überschrif ten 2/F-J/G elenkwelle montier en @ 2\mod_ 12023983427 88_78.doc @ 59 253
6.5 Install the PTO shaft
Pos: 16.34 /BA/Sic herheit/Gelenkw elle/Sich dr ehende Gelenkwelle _2 @ 0\ mod_119978169295 0_78.doc @ 3 4523
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
• Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
• Secure the tractor against rolling.
• Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
• Make sure that the protective devices are attached properly.
• Never use a PTO shaft, the protective devices of which have not been attached.
• Replace damaged protective devices immediately
• Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos: 16.35 /BA/I nbetriebnahme/ Schwader/Anba uG elenkwelle/A nbau Gelenkwelle angehängt e Schwader Bild @ 2\mod_120 2398077960_ 78.doc @ 59233
5
4
2
SW9070008
3
3
6
1
Figure 11
Pos: 16.36 /BA/I nbetriebnahme/ Schwader/Anba uG elenkwelle/A nbau Gelenkwelle angehängt e Schwader Te xt@ 37\mod_ 1263463772393_ 78.doc @ 339 645
• Switch off the engine and remove the ignition key.
• Install the PTO shaft (1) on the machine side (wide angle on machine side).
• Rotate the PTO shaft support (2) upwards.
• Then slide PTO shaft onto the PTO of the tractor. In doing this, ensure that the sliding pin
is securely engaged.
• Secure the PTO shaft guard against turning with the retaining chain (3).
Pos: 16.37 /BA/I nbetriebnahme/ Schwader/Maschin e anheben wenn Bedienseil @ 2\mod_12 02826885966 _78.doc @ 61845
Lifting the Machine
• The actuator rope (6) must be routed in such a way that no movements are
unintentionally triggered in any transport or working positions. The actuator rope must not
come into contact with the tractor tyres.
• Lift the machine slightly.
• Rotate the parking support (4) back 90°. Lock it in that position with the bracket (5) and
secure with spring cotter pin.
Pos: 17 /BA/----- Seitenumbruch---- -- @ 0\mod_1 196175311226 _0.doc @ 416 5