SERVICE WORK ON THE CHASSIS 12
61
V00336-11
– Position the upper triple clamp with the handlebar.
– Position the clutch line and wiring harness.
–
Mount screw
4
but do not tighten yet.
S03514-11
–
Position the combination instrument holder, and mount and
tighten screws
5
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
S04313-13
– Position the fork legs.
Bleeder screws
6
are positioned toward the front.
Info
The rebound damping is located in right fork leg REB
(red adjuster). The compression damping is located in
left fork leg COMP (white adjuster).
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
S03648-10
–
Tighten screws
7
.
Guideline
Screw, bottom triple
clamp
M8 15 Nm (11.1 lbf ft)
S03650-10
–
Tighten screw
4
.
Guideline
Screw, top steering
head
M20x1.5 12 Nm (8.9 lbf ft)
To Next Page
Loading...
