BRAKE SYSTEM 13
89
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake
pistons.
E00344-10
–
Remove cotter pin
4
, pull out pin
5
, and remove the brake
linings.
– Clean the brake caliper and the brake caliper bracket.
100397-01
–
Check that spring plate
6
in the brake caliper and sliding
plate
7
in the brake caliper bracket are seated correctly.
E00345-10
– Insert the new brake linings, insert the pin, and mount the cot-
ter pins.
Info
Always change the brake linings in pairs.
– Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
E01226-11
–
Correct the brake fluid level to level
A
.
Guideline
Level
A
(brake fluid level
below reservoir rim)
5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 144)
– Position the cover with the membrane. Mount and tighten the
screws.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
To Next Page
Loading...
