KTM 690 LC4 2007 - Page 73

6-16
Repair manual KTM 690 LC4 Art.-No. 3.206.045-E
– Position the valve cover and tighten the screws to 10 Nm.
NOTE: the gasket can usually be used again.
– Mount a new O-ring on the starter engine and grease.
– Slide the starter engine into the bore in the engine case, apply
Loctite to both screws
1 (M6x20) and tighten to 10 Nm.
– Unclamp the engine.
3