To Next Page

To Previous Page

16 COOLING SYSTEM 152

16.4 Correcting the coolant level in the compensating tank

Warning

Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.

– Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the engine

and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.

Warning

Danger of poisoning Coolant is poisonous and a health hazard.

– Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water immedi-

ately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If fuel is swallowed, con-

tact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of children.

Condition

The engine is cold.

The radiator is completely full.

Preparatory work

– Check the coolant level in the compensating tank. ( p. 148)

M00464-12

Main work

–

Remove cover



of the compensating tank.

– Add coolant to the MAX marking.

Coolant ( p. 195)

– Mount the cover of the compensating tank.

Questions and Answers:

Need help?

Do you have a question about the KTM RC 200 and is the answer not in the manual?

KTM RC 200 Specifications

General

Displacement	199.5 cc
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Rear Suspension	WP APEX Monoshock
Bore x Stroke	72 mm x 49 mm
Compression Ratio	11.5:1
Max Power	25 PS @ 10000 rpm
Max Torque	19.2 Nm @ 8000 rpm
Front Brake	300 mm disc
Rear Brake	230 mm disc
Fuel Tank Capacity	13.7 liters
Kerb Weight	160 kg
Front Suspension	WP APEX 43 mm Upside Down
ABS	Dual Channel
Tyre Front	110/70-17
Tyre Rear	150/60-R17
Ground Clearance	157 mm
Engine Type	Single Cylinder, Liquid Cooled