KTM RC 200 - Preparing for Use; Advice on First Use

7 COMBINATION INSTRUMENT 54
7.21 Setting the time
Condition
The ignition is on.
The motorcycle is stationary.
401303-01
– Press the MODE button briefly and repeatedly until ODO appears on the display.
– Press the MODE and SET buttons for 5 - 10 seconds.
The time display begins to flash.
– Set the hours display using the MODE button.
– Set the minutes display using the SET button.
– Press the MODE and SET buttons for 5 - 10 seconds.
The time is set.
7.22 Adjusting the shift speed RPM 1
Condition
The ignition is on.
The motorcycle is stationary.
401307-01
– Press the MODE button briefly and repeatedly until TRIP 2 appears on the display.
– Press the MODE button for 5 - 10 seconds.
The display RPM 1 appears.
Info
The engine speed can be set at intervals of 50.
RPM 1 is the engine speed above which the shift warning light starts flashing.
– Set the speed with the MODE and SET buttons.