KTM RC 200 User Manual

16 COOLING SYSTEM 155
L02265-10
–
Release bleeder screw

by three turns.
– Tilt the vehicle slightly to the right.
– Pour in coolant until it emerges without bubbles at the bleeder screw, and then mount
and tighten the bleeder screw immediately.
Coolant ( p. 195)
– Fill the radiator completely with coolant. Mount the radiator cap.
– Rest the vehicle on the side stand.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in
unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effective
exhaust extraction system.
– Start the engine and let it run warm.
M00464-11
– Stop the engine and allow it to cool down.
– When the engine is cool, check the coolant level in the radiator and, if necessary, add
coolant.
–
Remove the cap of the compensating tank

and top up the coolant level up to
the MAXmarking.
– Mount the cap of the compensating tank.
Finishing work
– Fit the front spoiler. ( p. 98)
– Install the left side cover. ( p. 101)

KTM RC 200 Specifications

General

Displacement	199.5 cc
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Rear Suspension	WP APEX Monoshock
Bore x Stroke	72 mm x 49 mm
Compression Ratio	11.5:1
Max Power	25 PS @ 10000 rpm
Max Torque	19.2 Nm @ 8000 rpm
Front Brake	300 mm disc
Rear Brake	230 mm disc
Fuel Tank Capacity	13.7 liters
Kerb Weight	160 kg
Front Suspension	WP APEX 43 mm Upside Down
ABS	Dual Channel
Tyre Front	110/70-17
Tyre Rear	150/60-R17
Ground Clearance	157 mm
Engine Type	Single Cylinder, Liquid Cooled