KTM RC 390 User Manual

14 WHEELS, TIRES 113
14.1 Removing the front wheel
Preparatory work
– Raise the motorcycle with the rear wheel stand. ( p. 78)
– Raise the motorcycle with the front wheel stand. ( p. 79)
L02277-10
Main work
–
Remove screws

and push the fender to the side.
–
Remove screw

and pull wheel speed sensor

out of the hole.
–
Loosen screw

and screws

.
–
Unscrew screw

about 6 turns and press your hand on the screw to push the wheel
spindle out of the axle clamp. Remove screw

.
Warning
Danger of accidents Reduced braking effect caused by damaged brake discs.
– Always lay the wheel down in such a way that the brake discs are not dam-
aged.
– Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of the
fork.
Info
Do not pull the hand brake lever when the front wheel is removed.

KTM RC 390 Specifications

General

Displacement	373.2 cc
Max Torque	37 Nm @ 7000 rpm
Transmission	6-speed
Cooling System	Liquid Cooled
Front Suspension	WP APEX 43
Rear Suspension	WP APEX Monoshock
Rear Brake	230 mm disc, single-piston floating caliper
Fuel Tank Capacity	13.7 liters
Seat Height	824 mm
Bore x Stroke	89 mm x 60 mm
Compression Ratio	12.6:1
Frame	Steel Trellis Frame, Powder Coated
Engine Type	Single-cylinder, 4-stroke
Max Power	43.5 PS @ 9000 rpm
Fuel System	Electronic Fuel Injection
Front Brake	320 mm disc, 4-piston radial caliper
ABS	Dual Channel ABS
Dry Weight	172 kg
Front Tire	110/70 R17
Rear Tire	150/60 R17
Ground Clearance	158 mm