S-42
03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM
DIESEL ENGINE
Oil Pressure Switch
1. Disconnect the connector of the oil pressure switch connector
(1P).
2. Check the state of the harness and if it is abnormal, please
replace it.
3. Measure the resistance between the terminal of the connector
(harness side) and chassis.
4. When the measurements are the below table value.
The ECU is normal. The oil pressure switch (1) is failure, then
please replace it.
5. When the measurements are out of the below table value.
The ECU is failure, then please replace it.
W1059711
Resistance Terminal 1 - Chassis Infinity
(1) Oil Pressure Switch
To Next Page
Loading...