4. - Safety
PROPUSH 2000 SERIES
15
7N018KUS_A
Box Spreader Trailer Type
Precautions for maintenance and repair
work
Before adjusting, maintaining or repairing the
machine, perform the safety shutdown procedure.
Repairs on elements under pressure or tension
(springs, pressure accumulators, etc.) must only be
carried out by competent persons with regulation
equipment.
Wear appropriate protective clothing (gloves,
shoes, goggles, hearing protection, etc.).
For your own safety and for correct machine
operation, only use original manufacturer parts.
Do not solder, weld or use a blow torch near fluids
under pressure or flammable components.
Make sure at least one tire on each side of the
machine is chocked properly before performing any
maintenance or repairs.
Rest the machine on the ground, release the
pressure from the hydraulic circuit and leave the
machine to cool down.
Make sure that the parts of the machine that need to
be lifted for maintenance or repair work are firmly
propped up.
When welding on this unit: DO NOT allow the
current to flow through the bearings, roller chains, or
scale weigh bars. Before any work is done on the
electrical circuit or before any electric welding is
carried out on the attached machine, disconnect the
machine from the tractor/truck electrical circuit. Also
disconnect alternator and battery terminals.
Projection of stones and foreign objects
For driver safety, always use a tractor equipped with
a cab.
Even when the machine is used properly, objects
may be thrown. Stones and other foreign objects
thrown by the moving parts can travel a
considerable distance. Keep all persons and
animals away from the danger zone.
To Next Page
