PROPUSH 2000 SERIES
28
6. - Putting into service
7N018KUS_A
Box Spreader Trailer Type
6.1.4 Machine requirements
Gross weight:
6.1.5 Light setup
Make sure to connect wiring for rear lights to tractor
before transporting machine. The lighting system
provided is intended for being transported by an
agricultural tractor. Ensure that lights and indicators
are clean and in good working order. When
attaching to a towing vehicle other than a tractor
always check lighting for proper operation as wiring
may vary.
6.1.6 Safety shields
Be sure all shielding is in place and functioning
properly. Replace all damaged or missing shielding
immediately. Refer to your parts manual and contact
your Kuhn dealer for replacement part ordering.
Model Empty unit weight + Load weight = Gross weight
Tractor weight up to
20 mph (32km/h)
2044 Horizontal
7620 lbs/
(3455 kg)+ ___________________=______________
2/3 of Gross weight =
Tractor weight
2044 Vertical
9440/
(4280 kg) + ___________________=______________
2/3 of Gross weight =
Tractor weight
2054 Horizontal
10,900/
(4945 kg) + __________________=______________
2/3 of Gross weight =
Tractor weight
2054 Vertical
12,520/
(5680 kg) + __________________=______________
2/3 of Gross weight =
Tractor weight
A tractor with the above recommended weight for your unit is normally adequate for towing the loaded
machine under average conditions.
When transporting a loaded spreader, use
reduced speed and be sure the tractor has
adequate weight and brakes.
To Next Page
