Kurzweil Artis - Entry Value; Exit Value

Multi Edit Mode
COMMON Page
8-22
Controller
Number
Controller
Destination
Description
134 KeyNum
Triggers playback of notes by Key Number—e.g., C4 is 60. Send a velocity
rst with Destination135, KeyVel.
135 KeyVel
Key Velocity
136 ProgInc
Program Increment—increments current Program number.
137 ProgDec
Program Decrement—decrements current Program number.
138 ProgGoto
Go to Program—selects Program.
139 MultiInc
Multi Increment—increments current Multi number.
140 MultiDec
Multi Decrement—increments current Multi number.
141 SetpGoto
Go to Multi—selects Multi.
145 TransUp
Transpose Up (ST)
146 TransDown
Transpose Down (ST)
Entry Value
The Entry Value parameter determines the value of the continuous controller that is sent as
a MIDI message when the current Multi is loaded. You can set this parameter to any number
between 0 and 127, or to None.
Pressing both Previous & Next buttons simultaneously will set this parameter to None.
If Entry Value is set to None, when you load the current Multi, no value will be sent. If you
specify an Entry Value, then a MIDI controller message with this value will be sent when
you load the current Multi.
Exit Value
The Exit Value parameter determines the value of the continuous controller that is sent as a
MIDI message when the current Multi is exited. You can set this parameter to any number
between 0 and 127, or to None.
Pressing both Previous & Next buttons simultaneously will set this parameter to None.
If Exit Value is set to None, then when you leave the current Multi, the controller will
remain at whatever value corresponds to its current position. If you specify an Exit Value,
then a MIDI controller message with this value will be sent when you close the current
Multi.