Kurzweil Artis - Pop up Messages; Alpha Wheel & Previous (-) and Next (+) Value Buttons; Value Jump Buttons

Program Mode
Selecting Programs
6-4
Pop Up Messages
Some actions cause the display to show pop up messages. After a short time the display
returns to show the current Program.
Alpha Wheel & Previous (–) and Next (+) Value Buttons
Use the Alpha Wheel or the Previous (-) and Next (+) buttons, to the right of the display
below the Alpha Wheel, to change the current Program. Turning the Alpha Wheel counter-
clockwise or pressing the Previous button will select the previous Program and turning the
Alpha Wheel clockwise or pressing the Next button will select the next Program. When
the highest or lowest Program is reached, the list will wrap back to the last or rst Program
respectively.
When scrolling through the Program list, the list moves through each Category, both factory
and User.
Value Jump Buttons
In Program Mode, the Value Jump double button press selects the rst Program of each
Category, as well as the Category Default Program of each Category (if a Category Default
Program has been set).
For more information on choosing a new Category Default Program for each Category, see
Choosing Category Default Programs on page 6-6.
If the User button is selected, Value Jump works the same way.