Kurzweil Artis - Assign; Enter + Zone (1-4) Button; Enter + Controller; Enter + Key

Features of the Artis
Double Button Presses
3-18
Assign
Assign is the secondary function of the Enter button.
The Assign symbol will be shown in the display next to parameters that can be selected with
Assign.
Pressing a key, switch, or moving a controller while holding down the Enter button will
perform Assign in the following cases.
Enter + Zone (1–4) Button
In Multi Edit Mode, holding the Enter button and pressing a Multi Zone Mute button will
jump to selecting that Zone. The currently selected Zone number can be seen on the top line
of the page.
Enter + Controller
In Multi Edit Mode, holding the Enter button and moving a controller (a Slider, Switch
button, Mod Wheel or Pedal) will jump to selecting the destination parameter of that
controller in the current Zone. This allows you to quickly assign a controller to a destination.
In Multi Edit Mode, holding the Enter button and moving the Pitch Wheel up or down
will jump to selecting the Bend Range Up or Bend Range Down parameters of the current
Zone.
Enter + Key
In Split Mode with the Split Key parameter selected, hold the Enter button and strike a key
to select the Split Key.
In Multi Edit Mode with the Low Key or High Key parameter selected, hold the Enter
button and strike a key to select the Low Key or High Key.