13. BRAKE SYSTEM
13-21
MXU 300/250
ASSEMBLY (MXU 250)
Reassemble the caliper in the reverse order
of disassembly procedures and observe the
following points.
Brake fluid specification and
classification: DOT4
Fit the O-ring.
Install and tighten the caliper housing bolts.
Torque: 2.2 kgf-m (22 Nm, 16 lbf-ft)
INSTALLATION (MXU 250)
Install the rear caliper and tighten the two
mounting bolts.
Torque:
Brake caliper mounting bolt (replace a
new one): 3.2 kgf-m (32 Nm, 25 lbf-ft)
With the tube ends contacted to the caliper
and install the washers and tighten the fluid
tube bolts.
Torque: 3.5 kgf-m (35 Nm, 25 lbf-ft)
Fill the system with brake fluid and bleed
air. (
page
13-13)
Wash the caliper components with fresh
brake fluid before assembly. Do not
wipe off brake fluid after washing the
components.
Replace the piston seal and dust seal
with new ones with brake fluid applied.
＊
Piston
Washers
Washers
To Next Page
Loading...
