14. FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM
14-19
MXU 300/250
INSPECTION
Inspect the handlebar.
Cracks/bends/damage →Replace.
INSTALLATION
Install handlebar and handlebar holder, then
tighten the four bolts.
Torque: 2.5 kgf-m (25 Nm, 18 lbf-ft)
• Be sure the upper handlebar holder
mark face to front.
• First tighten the bolts on the front side
of the handlebar holder, and then
tighten the bolts on the rear side.
＊
Mark
Holder Surface
Forward Mark
＊
Align the mark on the handlebar with the
lower handlebar holder surface.
＊
To Next Page
Loading...
