KYMCO MXU 300 - Page 42

2. FRAME COVERS/EXHAUST MUFFLER
2-7
MXU 300/250
FRONT CENTER COVER
REMOVAL/INSTALLATION
Remove the front cargo rack (see page 2-3).
Remove the two screws and front center
cover.
Installation is in the reverse order of
removal.
HANDLEBAR COVER
REMOVAL/INSTALLATION
Remove the front center cover (see page 2-
7).
Disconnect the fuel tank breather tube from
the handlebar cover.
Remove the two screws and raise the
handlebar cover.
Disconnect the speedometer cable from the
instrument.
Disconnect the instrument and ignition
switch connectors, then remove the
handlebar cover and instrument.
Installation is in the reserve order of
removal.
Screws
Screws
Fuel Tank Breather tube Speedometer Cable
Instrument Connecto
r
Ignition Switch Connecto
r
Push
During removal, do not pull the joint
claws forcedly to avoid damage.
＊