Kyocera DURAXE - Connect to a Different Wi-Fi Network; Wi-Fi Options Menu

Web and Data 65
Connect to a Different Wi-Fi Network
1. From the Home screen, press Menu (center softkey) > Settings > Wireless &
networks > Wi-Fi. Detected Wi-Fi networks are displayed in the Wi-Fi networks
section.
 To manually scan for available Wi-Fi networks, press Options (left softkey) >
Refresh.
2. Highlight another Wi-Fi network you want to connect and press > Connect to
network.
Note: If the wireless network you want to connect to is not in the list of detected
networks, press Options (left softkey) > Add network. Enter the wireless
network settings and press Save (right softkey).
Wi-Fi Options Menu
1. From the Home screen, press Menu (center softkey) > Settings > Wireless &
networks > Wi-Fi.
2. Press Options (left softkey). The following options are available:
 Add network to add a new Wi-Fi network.
 Saved networks to display the saved networks list.
 Refresh to manually scan for available Wi-Fi networks.
 Advanced to configure advanced Wi-Fi settings, which include:
 Network notification to notify you when an open network is available.
 Scanning always available to let location services and other apps scan for
networks, even when Wi-Fi is off.
 Keep Wi-Fi on during sleep to stay connected to Wi-Fi when the screen
goes to sleep to conserve mobile data usage.
 Wi-Fi frequency band to specify the frequency band for Wi-Fi.
 Install certificates to install the certificates for communicating via Wi-Fi.
 WPS Push Button to set up a Wi-Fi Protected Setup connection by pressing
the set up button on the router.